Horizontal multi-stage centrifugal pump installation order (1) The unit shipped to the scene, with the base has been installed motor, leveling base can be removed without having to pump and motor. (2) The base on the ground, near the anchor in the ground pad wedge-shaped horn, the base pad 20 to 40 mm high, ready to level after filling the slurry used. (3) Check the level of the base with a level meter, flatten the foot nut to fill the base with grout, until the cement should be checked again after the level of dryness. (4) When the unit power is large, in order to facilitate the transportation, the pump, the motor and the base may be packaged separately. At this time, the user is required to install and correct the pump unit. The method is as follows: a. Remove the dirt on the feet and the motor feet, and put the pump and motor on the base. b. adjust the level of the pump shaft, leveling tighten the nut properly to prevent ambulation c. lift the motor so that the pump coupling and motor coupling with the motor down to do the appropriate position; d. adjust the two coupling The gap is about 5mm, and the correction of motor shaft and shaft axis coincide, the method is to place the flat ruler on the coupling, the two cylindrical coupling with the flat feet flat, if not overlap, should Adjust the relative position of the motor or pump, or pad to adjust the sheet; e. In order to check the accuracy of the installation, in several different locations on the circumference of the coupling with a feeler gauge to measure the gap between the two coupling plane, the coupling The difference between the maximum and minimum clearances in the plane shall not exceed 0.3 mm in one week, and the difference between the two ends of the center line shall not exceed 0.1 mm. (5) When the unit is not with the base, you need to install directly on the basis of the method similar to 4, but should pay more attention to the correction.
Barbecue tools have a lot of types, barbecue fork, barbecue spatula, barbecue hairbrush, barbecue tong, barbecue knife, bamboo barbecue skewer, steel barbecue skewer, stainless steel wire cleaning brush, copper wire cleaning brush, corn fork, salt-pepper tube, steak fork,steak knife,and so on. This is a necessity for BBQ.We can also form a complete set according to the requirement of the customers, as you choose.
BBQ Tools
BBQ Tools,BBQ Aprons,BBQ Tong,Barbecue Grill
Yangjiang Yangdong Hongli Industries Co.,Limited , https://www.hongli-industry.com
没有评论:
发表评论