Instructions
1.Thread the needle through the barrel. Put the pointed end through the back end of the barrel, leaving the looped end toward the back.
2.Load the barrel onto the tattoo machine. Make sure the larger end is the end you attach to the frame.
3.Attach the loop on the back of the needle to the front edge of the armature bar. This will make the needle move in and out of the tube.
4.Use rubber bands to hold the needle back and keep it tight against the back of the tube. This makes sure the needle does not move around while you work.
5.Adjust the tube down until you have a 16th or a 32nd of an inch showing at the end where it will penetrate the skin. You don't want too much or too little of the needle showing. Too little will not get the ink far enough under the skin, while too much will overwork the skin and cause more pain and bleeding.
6.After assembly, connect your machine to a power source. Make sure the foot pedal is within reach, and switch the power source on.
7.Step on the foot switch, and the circuit will cause the needle to move up and down. If this happens, the machine runs properly.
Tattoo Accessories is a very big Category,which including lots of kinds of products which involved for tattoo products or tattoo job.
The tattoo accessories is not necessary in the process for tattoo,but sometimes you may need it.
Professional Tattoo Accessories Manufacturer in China. Specialize In Manufacturing Wholesale Tattoo Chair , Tattoo Arm Rest, Tattoo Practice Skin, Tattoo Ink Caps, etc products. welcome to come to the consultation.
Tattoo Accessories
Tattoo Accessories, Tattoo Chair, Tattoo Arm Rest, Tattoo Practice Skin, Tattoo Ink Caps
Redtop Tattoo Supply Co., Limited , http://www.redtop-tattoo.com
没有评论:
发表评论